Features:
- A 95% reduction in the water used is normal when compared to constant flow immersion sterilisers.
- At least a 95% reduction in the cost of heating the water.
- Virtually no steam produced which reduces the risk of airborne nasties being picked up by the steam and condensing on surfaces above, with drips contaminating the carcasses.
- Activated by insertion of the tool into the unit. Safe and easy for operators.
- Fully automatic operation gives consistent results with any operator.
- New easy access design allows for ease of servicing, minimising down time
- Comes standard with water level sensing, which purges any air that gets into the tank automatically, preventing the heater element overheating and the thermal overload tripping.
- All the Econoliser models work with any temp. of water. Supplying the Econoliser with cold water and letting the built in water heater heat the water is the most efficient and least expensive way of heating the water.
- The built in water heater ensures the water temperature is always above 82°C/180°F, no matter what temperature the water supply is (setpoint is 90°/194°F)
- Because the Econolisers use so little water and therefore very little electrical energy to heat them, energy from a renewable source can be used.
- Pre sterilization High Pressure rinse cycle, prevents build up of bone and fat where blade enters motor housing.
Options:
- External Temperature display which shows the temperature of the water leaving the nozzles
Specification:
- Supply Voltage……………………………………………………………………………..:- 240VAC 50/60Hz
- Max Load current…………………………………………………………………………:- 23A
- Dynamic Water Pressure min……………………………………………………….:- 3Bar/45psi
- Sterilisation Min water Flow rate………………………………………………….:- 15L/min or 4gals/Min
- Sterilisation Cycle time Factory set……………………………………………….:- 4.5secs.
- Sterilisation Water used per cycle…………………………………………………:- ≤0.84Ltrs. or 1.8 US pints
- H P rinse cycle Dynamic water pressure………………………………………..:-12bar/175psi —–20Bar/290psi
- H P minimum flow rate………………………………………………………………….:-25L/Min or 5.5 Gals/min
- H P rinse cycle time factory set :- 2secs
H P Water used per cycle……………………………………………………………….:- 0.8Ltrs/1.4imp pints
Reviews
There are no reviews yet.